RAZR fit
quick start guide
Simple
Adjustability
that matters
The RAZR Fit Driver features two interchangeable weights in the toe and heel thatenable you to promote either a Draw or Neutral ball flight.
The RAZR Fit Driver uses an advanced hosel that allows you to adjust the face angle on your driver. You can select from three different settings - O (Open), S (Square) or C (Closed).
OPTIFIT TECHNOLOGY The RAZR Fit Driver can be adjusted for both face angle (using the hosel Cog) and center of gravity (using the weight screws) using a straightforward 3 step process.
- Face angle adjustment allows you to set the club to your preferred look at address.
- Adjusting the weight screws will affect the direction the ball curves while in flight.
- A final face angle adjustment can optionally be used to help influence the starting direction of your drives.
how to
use the
Optifit
hosel
STEP 1 - ADJUSTING FACE ANGLE
Your RAZR Fit Driver is preset with the club face in the square (S) position. If this is the look you prefer at address, no adjustment is necessary at this time. If you prefer the club face to look more open at address, simply loosen the screw at the bottom of the club (going into the shaft) with the accompanying wrench and set the Cog on the hosel to the open (O) position. If you prefer the club face to look closed at address, set the hosel Cog to the closed (C) position.
how to
use the
Optifit
weighting
12 GRAM
WEIGHT
2 GRAM
WEIGHT
2 GRAM
WEIGHT
12 GRAM
WEIGHT
NEUTRAL
To promote a Neutral ball flight, use the torque wrench provided to screw the 2 gram weight into the heel of the clubhead and the 12 gram weight into the toe until you hear a click.
DRAW
To promote a Draw ball flight or reduce a slice, use the torque wrench provided to screw the 12 gram weight into the heel of the clubhead and the 2 gram weight into the toe until you hear a click.
STEP 2 – ADJUSTING WEIGHT SCREWS
Your RAZR Fit Driver is also preset with the weight screws in the Neutral position (12 gram weight in the toe, 2 gram weight in the heel). If, after hitting balls you're happy with your ball flight, no further adjustment is necessary. If you would like to produce more Draw/less fade, simply unscrew the weights and switch them, placing the 12 gram weight in the heel and the 2 gram weight in the toe.
STEP 3 - FINE-TUNING/REVISITING FACE ANGLE
AFTER HITTING BALLS:
After completing the first two steps, your RAZR Fit Driver will be dialed-in and noticeably improving your ball flight. If you're still looking to tweak your ball flight slightly, you should revisit the face angle setting (since it was initially set based solely upon looks without taking ball flight into account). If you have the weights set in either the Neutral or Draw position and you're hitting the ball slightly more left than you would like, moving the face angle from closed (C) to square (S) or square (S) to open (O) will help straighten out your shots. If you're hitting the ball slightly more right than you prefer, moving the club face angle from open (O) to square (S) or square (S) to closed (C) will help straighten out your ball flight.