Sign In
Forgot Your Password?

Need an Account? Join Today!

Blog

X2 Hot Driver – Adjust Loft and Lie Angle

By:
Callaway Golf Staff

Callaway Club Specialist, Ross Stewart shows you how to adjust loft and lie angle on the new X2 Hot Driver.

Here is how you can adjust loft and lie angle on your X2 Hot Driver:

Loft and Lie Adjustability Instructions

We recommend that you make adjustments in the order below:

1. LOFT options
• stated loft (S)
• stated plus one degree (+1)
• stated plus two degrees (+2)
• stated minus one degree (-1)

The loft lets you adjust launch angle and backspin to influence trajectory. The club comes set in the stated “S” position. To change the loft, loosen the screw at the bottom of the shaft and rotate both cogs until the loft setting you want is aligned with the white hash mark on the shaft and the white hash mark on the driver hosel assembly. Tighten the screw until you hear a click.

Note: Your desired loft may appear on the upper or lower cog, depending on loft and lie angle combination.

2. LIE options
• Neutral (N)
• Draw (D)

Once the loft has been determined, hold that cog in place while you rotate the other cog between Draw “D” and Neutral “N”. This will change the lie angle and influence the starting direction of your shots.

If you want to minimize a slice or enhance a draw, rotate the lie cog to the Draw “D” position, which will make the lie angle more upright. If you want to work the ball both ways, for either a fade or a draw, rotate the cog to the “N” position.

Remember that this designation could appear on the upper or lower cog, and make sure the desired setting is aligned with the white hash mark on the shaft.

Always tighten the screw until you hear a click.

The figure below illustrates the do’s and don’ts for adjusting your hosel settings:

 

hosel-dos-donts-x2hot

 

Here’s an example:

To adjust your 10.5° clubhead to 11.5 degrees of Loft and a Neutral position:

• Find “ +1 ” on one of the two cogs and line it up with the hash marks on the shaft and clubhead hosel.
• On the other cog, find the “N” setting and align it with the two hash marks.
• Tighten screw until you hear a click.

POSTED IN Driver